How to Change Steering Wheels from a Quick Release

Written By: Bench Espiritu
  • Comments: 0
  • Favorites: 0

Difficulty

Very easy

Steps

4

Time Required

00:15:00

Sections

1

Flags

0

Introduction

A quick overview on how to install a Sparco steering wheel on a MX-5 Miata Cup Car. The wheel will be installed on a works bell hub.

  1. Remove the quick release from the vehicle and set down on a flat table.

    • Remove the quick release from the vehicle and set down on a flat table.

    Edit

  2. Once you have everything ready, start to unbolt the steering wheel bolts with the 3mm Allen Wrench. There are 6 bolts in total, make sure to keep track of the bolts when removed.

    • Once you have everything ready, start to unbolt the steering wheel bolts with the 3mm Allen Wrench.

    • There are 6 bolts in total, make sure to keep track of the bolts when removed.

    Edit

  3. Remove the wheel from the quick release and set the wheel aside. Line up the top marker of the quick release to be on top of the new steering wheel to make sure its straight. Add Screws and tighten them to a snug tight. But not too tight.

    • Remove the wheel from the quick release and set the wheel aside.

    • Line up the top marker of the quick release to be on top of the new steering wheel to make sure its straight.

    • Add Screws and tighten them to a snug tight. But not too tight.

    Edit

  4. Lastly, install the horn button and the sticker that is provided with the wheel. Then snap the wheel into the car and enjoy!

    • Lastly, install the horn button and the sticker that is provided with the wheel.

    • Then snap the wheel into the car and enjoy!

    Edit
Conclusion

You have no upgraded your steering wheel. Time for a drive and enjoy!

Author

Bench Espiritu

Member since: 05/02/2014

2,060 Reputation

18 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 0

All Time: 249

Copyright© 2019 Moddit