Skip to main content
Editing Step 5 —

Step Type:

Drag to rearrange

The install of the rear sub-frame collar install is a lot more straight forward. Unlike the front portion where you had to loosen a panel to loosen the sub-frame area, here you just un-bolt and re-tighten; read on to see how.

Using your ____ Socket, loosen the rear main bushing bolt from the body. This area is located right behind the exhaust muffler. Here after loosening the bolt we posed how you should layout the collar bushings.

Because we had previously installed the Tomei Type-60R exhaust which has no muffler, our area to access the rear sub-frame bushing bolts was fairly open. Keep in mind you might have to remove the stock muffler if it is in your way.

After holding the sub-frame collars in the correct position to demonstrate their final placement locations, we then slid the bottom collar in first.

After securing the lower collar in place on the bolt, we then placed the top collar so that the bolt would pass through both sub-frame collars and the sub-frame bushing.