Once the bolts are torqued and set,you can go ahead and connect the sway bar end link.

Tighten down the end link once its connected. But make sure when you're screwing the nut on, the stud is not spinning. You can use an Allen key to keep that from happening.

Once the end link is complete, you can now finnish up by clicking in the clip for the ABS line and then bolting down the brake line as well.

Once everything is buttoned up on one side, go ahead and repeat everything on the other side.

After all 4 corners are installed, just give everything a once over to make sure all the bolts and nuts are torqued down.

Then Install the wheels, torque the lug nuts, and drive!

Also, don't forget to get an alignment after the suspension has settled (about a week or so).